Next: RESULTS OFF
Up: Primary Command RESULTS
Previous: RESULTS LOADCASE Loadcase_name [Range]
This command is used to specify the nodal attribute and component of analysis results required for assessment. In general the names of the attributes and components will be user-defined, and these will be offered in the form of a menu in a similar way to the standard commands available in FEMVIEW..
Nodal results are sets of results whereby the values are submitted nodewise and, in general, a contour plot will produce smooth contours across element boundaries. In a multi-material model it is possible to submit material-dependent nodal results whereby discontinuities may be seen at the material boundaries. It is also possible to submit multi-surface results.
For selection of the required material and/or surface see the `RESULTS RANGE' command. In cases where a material or surface has not been specified but multi-material and/or multi-surface results have been input then results for the first material and/or surface will be used.
For components which are complex an optional function can be specified by the user to produce a real value that can be presented. If the complex number is represented by x + iy the functions that can be applied are:
Complex_part | Comments | Equation used |
REAL | Produces the real component of the complex | x |
number. (This is the default if no function is | ||
specified) | ||
IMAGINARY | Produces the complex component of the | y |
complex number. | ||
ANGLE | Resolves the complex number at a given | |
angle , where is in degrees | ||
MAGNITUDE | Produces the magnitude of the complex | |
number. | ||
PHASE | Calculates the phase angle of the complex | |
number. The angle returned is in the range | ||
degrees. |
Notes:
Examples:
Selects the all component of displacement in the current loadcase as the current results
See also the following commands
'RESULTS LOADCASE'
'RESULTS RANGE'
'UTILITY TABULATE RESULTS'
Femsys Limited