Pioneer 4

related topics
{ship, engine, design}
{math, energy, light}
{@card@, make, design}
{system, computer, user}

Pioneer 4 was a spin-stabilized spacecraft launched as part of the Pioneer program on a lunar flyby trajectory and into a heliocentric orbit making it the first U.S. probe to escape from the Earth's gravity. It carried a payload similar to Pioneer 3: a lunar radiation environment experiment using a Geiger-Müller tube detector and a lunar photography experiment. It passed within 60,000 km of the Moon's surface. However, Pioneer 4 did not come close enough to trigger its photoelectric sensor. The spacecraft was still in solar orbit as of 1969.

Contents

Spacecraft design

Pioneer 4 was a cone-shaped probe 51 cm high and 23 cm in diameter at its base. The cone was composed of a thin fiberglass shell coated with a gold wash to make it electrically conducting and painted with white stripes to maintain the temperature between 10 and 50 degrees Celsius. At the tip of the cone was a small probe which combined with the cone itself to act as an antenna. At the base of the cone a ring of mercury batteries provided power. A photoelectric sensor protruded from the center of the ring. The sensor was designed with two photocells which would be triggered by the light of the Moon when the probe was within about 30,000 km of the Moon. At the center of the cone was a voltage supply tube and two Geiger-Müller tubes. A transmitter with a mass of 0.5 kg delivered a phase modulated signal of 0.1 W at a frequency of 960.05 MHz. The modulated carrier power was 0.08 W and the total effective radiated power 0.18 W. A despin mechanism consisted of two 7 gram weights which spooled out to the end of two 150 cm wires when triggered by a hydraulic timer 10 hours after launch. The weights were designed to slow the spacecraft spin from 400 rpm to 6 rpm and then weights and wires were released.

Pioneer IV was named Artificial Planet Two. Science News Letter March 14, 1959.

Launching vehicle

Pioneer 4 was launched with a Juno II launching vehicle, which also launched Pioneer 3. Juno II closely resembled the Juno I (Jupiter-C based) vehicle that launched Explorer 1. Its first stage was a 64 feet elongated Jupiter IRBM missile that was used by the US Army. On top of the Jupiter propulsion section was a guidance and control compartment that supported a rotating tub containing the rocket stages 2, 3 and 4. Pioneer 4 was mounted on top of stage 4.[1]

Full article ▸

related documents
2001 Mars Odyssey
Magnetoplasmadynamic thruster
Flutter (electronics and communication)
Shields (Star Trek)
Lunokhod 1
Centrifugal governor
Pitot tube
Ranger 1
Reaction wheel
Sputnik program
Vanguard TV3
Space station
Project Mogul
Ranger 2
Chord (aircraft)
Syncom
German Type XIV submarine
USS Glenard P. Lipscomb (SSN-685)
Combat engineering vehicle
Hydra 70
D2G reactor
Sturgeon class submarine
Variable Specific Impulse Magnetoplasma Rocket
Arsenal ship
S7G reactor
Russian submarine K-141 Kursk
Salyut program
Nuclear explosive
Sailing ship
Luna 24