Next: GEOMETRY COPY part [name] trnam [times] Up: GEOMETRY BODY Control Previous: GEOMETRY BODY GENERAL [bnam] set_outer [set_inner*][elt]or
Next: GEOMETRY COPY part [name] trnam [times]
Up: GEOMETRY BODY Control
Previous: GEOMETRY BODY GENERAL [bnam] set_outer [set_inner*][elt]or
This command is used to define a prismatic body created when a 'region' is swept. The command is not intended for interactive use; it is provided solely to allow archiving and subsequent recreation of prismatic bodies and is documented here for completeness. Users wishing to create prismatic bodies should create a surface with the command GEOMETRY SURFACE REGION and then sweep the resulting surface using a pre-defined translation.
| bnam | = | name of the body , used for later references. |
| snam_front | = | name of the surface created with GEOMETRY SURFACE REGION |
| that was swept to create the body. | ||
| snam_back | = | name of the surface opposite snam_front that was created with |
| a GEOMETRY SWEEP command. | ||
| set_sides | = | set containing the side surfaces created when snam_front was swept. |
| elt | = | element type on the body, either PE6 or PE15. Refer to command |
| MESHING TYPES for a detailed description. |
Return Level: GEOMETRY BODY
See also the following commands
'GEOMETRY SURFACE REGION'
'LABEL GEOMETRY BODIES'
'MESHING TYPES'
'UTILITY DELETE BODIES'
'UTILITY TABULATE GEOMETRY BODIES'
'VIEW GEOMETRY'
Femsys Limited