GEOMETRY LINE NODES [lnam] pnam1 pnam2 nono1 nono2

      

This command is used to define a polyline from manually defined nodes .

lnam = name of the line, used for later references to the line.

pnam1 = name of a point which defines the start point of the line.

pnam2 = name of a point which defines the end point of the line.

nono1 = the number of the first node of a consecutive series of nodes on the line.

nono2 = the number of the last node on the line.

 

Figure 2.79: Definition of a line from nodes

Return Level: GEOMETRY LINE

Examples:

1.

GEOMETRY LINE NODES LS1 P1 P2 1 4

Defines a line in terms of actual node positions.

See also the following commands

'LABEL GEOMETRY LINES'
'UTILITY DELETE LINES'
'UTILITY TABULATE GEOMETRY LINES'
'VIEW GEOMETRY'