Next: MESHING SHAPE Part Projection Up: Primary Command MESHING Previous: MESHING OPTIONS UNLOCK Part
Next: MESHING SHAPE Part Projection
Up: Primary Command MESHING
Previous: MESHING OPTIONS UNLOCK Part
This command is used to re-number node numbers in order to improve solution
time during the analysis of the model.
| Control | Comments | |
| GLOBAL | [XYZ] | The node numbers are re-numbered according |
| [YXZ] | to the global coordinate system in increasing | |
| [ZXY] | `xyz' order as specified. The default is `XYZ'. | |
| [XZY] | ||
| [YZX] | ||
| [ZYX] | ||
| DIAGONAL | The direction of the maximum distance between points | |
| is calculated and used to define the direction of the | ||
| z-axis to be used for re-numbering. The nodes will be | ||
| re-numbered in the plane normal to the z-axis. | ||
| Cord_sys | The node numbers are re-numbered according to the | |
| specified rectangular coordinate system. The | ||
| nodes will be numbered in increasing x direction, | ||
| then y direction and then z direction. |
Examples:
Re-numbers the nodes with reference to the rectangular coordinate system CYS7.
See also the following commands
Femsys Limited