CONSTRUCT LMASK

     

FEMGEN Command only.

This command is used to define a load mask in order to limit the region over which a load acts. Load masks may be defined in terms of a part's parametric space or in terms of the global coordinate system. A local coordinate system may be attached to a global load mask in order to re-orientate it.

Load masks may be attached to a load using the command PROPERTY ATTACH.

CONSTRUCT LMASK has the following sub-commands:

2.3.3.3 CONSTRUCT LMASK LINE - Define a load mask for a line load

2.3.3.4 CONSTRUCT LMASK SURFACE - Define a load mask for a surface load

2.3.3.1 CONSTRUCT LMASK BODY - Define a load mask for a body load

2.3.3.2 CONSTRUCT LMASK GLOBAL - Define a load mask in the global coordinate system