GEOMETRY UNSPLIT name1 [name2]

  

This command is used to reverse the effect of the GEOMETRY SPLIT command by making a single line from two lines.

name1 = name of an existing point or the name of an existing line. The graphics cursor may be used to pick an existing point or line.

name2 = where `name1' was the name of a line then `name2' must be the name of a second existing line that is joined to the first line. The graphics cursor may be used to pick the second line.

Notes:

1.

Naming of unsplit lines
The single line that results from the UNSPLIT operation takes the name of the original line that was previously `split' using the GEOMETRY SPLIT command

2.

Parts deleted
The line created by the original SPLIT operation will be deleted. Note that the point between the two lines will also be deleted unless any other lines make use of it in which case it will not be deleted.

3.

Line divisions
The number of divisions on the single line formed by the UNSPLIT operation will be the sum of the divisions on the two component lines.

See also the following commands

'LABEL GEOMETRY LINES'
'GEOMETRY SPLIT'
'UTILITY DELETE LINES'
'UTILITY TABULATE GEOMETRY LINES'
'VIEW GEOMETRY'